Physical Address
304 North Cardinal St.
Dorchester Center, MA 02124
📚 Introduction to ASTM D2663-14 ASTM D2663-14 (Reapproved 2019) provides the standard test methods for evaluating the degree of carbon black dispersion in rubber. Proper dispersion is fundamental to achieving optimal reinforcement and physical properties in vulcanized rubber compounds. The…
📐 Specimen Geometry and Preparation Per ASTM D2664-04, this test method is strictly applicable to cylindrical rock core specimens tested in an undrained state. Specimen preparation is governed by Practice D4543, which mandates specific dimensional tolerances to minimize end effects…
ASTM Designation D2661−24 establishes the standard specification for Acrylonitrile-Butadiene-Styrene (ABS) Schedule 40 plastic pipe and fittings utilized in drain, waste, and vent (DWV) applications. This American National Standard, approved for use by U.S. Department of Defense agencies, covers single and…
📐 Scope and Overview of ASTM D2662 ASTM D2662 – 96a established the comprehensive requirements for Polybutylene (PB) plastic pipe featuring a controlled inside diameter. Designated as SIDR-PR (Standard Inside Dimension Ratio – Pressure Rated), this specification was critical for…
ASTM D2658-18 (Reapproved 2023) provides the definitive methodology for determining the interior and exterior dimensions of fiberboard boxes. Administered by ASTM Subcommittee D10.27 on Fiberboard Shipping Containers, this standard is a cornerstone of packaging quality control. It covers regular slotted…
ASTM D2659-16 (Reapproved 2023) establishes a standardized method for determining the column crush properties of blown thermoplastic containers, simulating the axial compressive stresses encountered during stacking, transport, and storage. The test is conducted at a constant rate of compressive deflection…
ASTM D2656-20 establishes the standard for crosslinked polyethylene (XLPE) insulation designed for power cables rated from 2001 V to 35 000 V. This specification applies to conductor sizes 8 AWG (8.37 mm²) and larger, with a base polymer consisting substantially…
📐 Scope and Applicable Materials This practice establishes general procedures for the heat fusion joining of polyolefin pipe and fittings, specifically excluding polyethylene (PE) pipe and fittings (which are covered under Practice F2620). The standard is applicable to materials of…
📐 Overview and Scope These test methods (D2654-22) provide standardized procedures for measuring moisture in textile materials, including moisture content, pick-up, and regain. They are applicable to all natural and man-made fibers, from raw fiber to finished fabric, as well…
📜 Scope and Application Overview ASTM D2655-23 governs the specification for crosslinked polyethylene (XLPE) insulation used in electrical wire and cable. This standard applies to conductor sizes 14 AWG (2.08 mm²) and larger, rated for voltages not exceeding 2000 V,…