Category ASTM Standards

📐 Scope and Referenced Documents This specification, designated D2672-20, covers the socket produced for solvent cement joints on both pressure and non-pressure IPS PVC pipe. It includes requirements for socket dimensions, burst pressure, and joint tightness tests of solvent cemented…

ASTM D267-82 (Reapproved 2020) provides the standard specification for gold bronze, pale gold bronze, and rich gold bronze powders used in decorative and protective coatings. These pigments, composed of finely polished metal flakes suspended in a lubricant, are designed to…

📐 Test Apparatus and Specimen Configuration ASTM D2670-20 specifies the use of the Falex Pin and Vee Block Lubricant Test Machine for conducting a preliminary evaluation of the wear properties of fluid lubricants. The test geometry involves a rotating steel…

ASTM D2668 −07 (Reapproved 2021) provides a standardized infrared absorption methodology for the quantitative determination of two key oxidation inhibitors—2,6-di-tert-butyl-p-cresol (DBPC) and 2,6-di-tert-butyl phenol (DBP)—in electrical insulating mineral oils. The method is effective for concentrations up to 0.5 % by…

ASTM D2669-16, titled Standard Test Method for Apparent Viscosity of Petroleum Waxes Compounded with Additives (Hot Melts), provides a standardized procedure for determining the flow characteristics of hot melt adhesives and wax blends. This testing is critical for quality control…

📐 Scope and Referenced Documents ASTM D2666-96a is an American National Standard that specifies requirements for polybutylene (PB) plastic tubing. The tubing is outside diameter controlled and produced in standard thermoplastic tubing dimension ratios. It is pressure rated for water…

📖 Overview and Scope of D2667-95 ASTM D2667-95 (Reapproved 2008) is the standard test method for assessing the biodegradability of alkylbenzene sulfonates. This method acts as an index for the suitability of the sulfonate for general use as a surfactant,…

ASTM D2665-24 is an American National Standard that specifies requirements for poly(vinyl chloride) (PVC) plastic drain, waste, and vent (DWV) pipe and fittings. It covers materials, dimensions and tolerances, pipe stiffness, crush resistance, impact resistance, and solvent cement properties. The…

📚 Introduction to ASTM D2663-14 ASTM D2663-14 (Reapproved 2019) provides the standard test methods for evaluating the degree of carbon black dispersion in rubber. Proper dispersion is fundamental to achieving optimal reinforcement and physical properties in vulcanized rubber compounds. The…

📐 Specimen Geometry and Preparation Per ASTM D2664-04, this test method is strictly applicable to cylindrical rock core specimens tested in an undrained state. Specimen preparation is governed by Practice D4543, which mandates specific dimensional tolerances to minimize end effects…

ASTM Designation D2661−24 establishes the standard specification for Acrylonitrile-Butadiene-Styrene (ABS) Schedule 40 plastic pipe and fittings utilized in drain, waste, and vent (DWV) applications. This American National Standard, approved for use by U.S. Department of Defense agencies, covers single and…

📐 Scope and Overview of ASTM D2662 ASTM D2662 – 96a established the comprehensive requirements for Polybutylene (PB) plastic pipe featuring a controlled inside diameter. Designated as SIDR-PR (Standard Inside Dimension Ratio – Pressure Rated), this specification was critical for…