Physical Address
304 North Cardinal St.
Dorchester Center, MA 02124
SAE J500-1995 is a recommended practice focused on inch serrated shaft ends and corresponding hole dimensions for service applications. It provides standard dimensions, tolerances, and formulas for 36 and 48 serration configurations, ensuring consistent fits and reliable performance in automotive…
SAE J493, originally issued in 1915 and stabilized in 2013, specifies the requirements for rod ends and clevis pins used in automotive and industrial applications. This article provides an overview of the standard, its material specifications, and important considerations for…
SAE J495-2004, originally issued in 1957 and cancelled in May 2004, was the industry standard for solid straight pins used in various mechanical assemblies. While it is no longer recommended for new designs, understanding its specifications helps engineers working with…
Overview and Cancellation SAE J497, first issued in 1957, provided the dimensional requirements for unhardened ground dowel pins used in precision alignment. However, this standard was cancelled in May 2004 as it is obsolete, with current specifications now managed under…
SAE J483 is a recommended practice that defines the dimensions, tolerances, and material requirements for high and low crown hex nuts, commonly referred to as blind or acorn nuts. These fasteners are widely used in automotive and industrial applications where…
The SAE J490 standard, originally issued in 1920 and stabilized in 2012, provides a foundational overview of ball joints used in surface vehicles. It covers general technology, products, and processes but defers to manufacturers for specific design considerations. This article…
SAE J468 is a stabilized surface vehicle standard that defines the chemical composition requirements for two widely used zinc alloys in both ingot and die casting forms. Originally issued in 1934 and stabilized in 2018, the standard reflects mature technology…
SAE J46 establishes uniform road test procedures for evaluating wheel-slip brake-control systems—commonly known as anti-lock braking systems (ABS)—on passenger cars, trucks, buses, and combination vehicles. The standard focuses on vehicle stability, maneuverability, and stopping distance across various road surfaces, including…
SAE J48-2023 is a recommended practice that establishes preferred methods for indicating liquid levels in fluid compartments of off-road work machines. This standard applies to any fluid compartment on equipment as defined in SAE J1116 and ISO 6165, ensuring consistent,…
SAE J462-2018 is the definitive standard for copper base casting alloys used in automotive and other engineering applications. It prescribes chemical composition and mechanical property requirements for a wide range of UNS-designated alloys, covering common casting methods such as sand,…