Physical Address
304 North Cardinal St.
Dorchester Center, MA 02124
📐 Scope and Test Principle ASTM D2595-22 provides a standardized method for determining the evaporation loss of lubricating greases across a wide temperature range. While Test Method D972 is limited to a maximum of 149 °C (300 °F), D2595-22 extends…
⚙️ Overview of the Four‑Ball EP Test Method ASTM D2596‑20 establishes a rigorous framework for evaluating the extreme‑pressure (EP) properties of lubricating greases using the Four‑Ball EP Tester. In this method, a rotating steel ball is pressed against three stationary…
📐 Scope and Specimen Requirements ASTM D2591-07 (Reapproved 2020) specifies a test method for determining the linear density of short lengths of “as produced” elastomeric yarns made from rubber, spandex, or other elastomers. It is applicable to yarns in the…
🔬 Scope and Application This test method covers the determination of butadiene-1,3 purity and hydrocarbon impurities including propane, propylene, isobutane, n-butane, butene-1, isobutylene, propadiene, trans-butene-2, cis-butene-2, butadiene-1,2, pentadiene-1,4, and various acetylenes (methyl, dimethyl, ethyl, and vinyl) in polymerization grade butadiene.…
ASTM D2594/D2594M-21 defines a standard test method specifically designed for evaluating the stretch and growth characteristics of knitted fabrics that exhibit high extension under low tension, commonly referred to as low-power stretch fabrics. Unlike tests for rigid or power-net fabrics,…
📐 Scope and Significance of McNett Wet Classification This test method, designated ASTM D2589/D2589M, covers the determination of the length distribution and fines content of milled asbestos fiber through wet classification using the McNett fiber classifier. The values stated in…
This article provides a comprehensive overview of ASTM D2590/D2590M −98 (Reapproved 2019), the standard test method specifically designed for the controlled sampling of milled chrysotile asbestos fibers. The standard outlines a rigorous protocol for obtaining representative test specimens from bulk…
🧪 Scope and Principle of the Barcol Impressor Test ASTM D2583-24 defines a standardized method for measuring the indentation hardness of rigid plastics, encompassing both reinforced and non-reinforced types, through the use of a Barcol Impressor. The test is specifically…
📜 Scope, Significance, and Limitations ASTM D2584‑18 provides a standardized procedure for determining the ignition loss of cured reinforced resins. Under the specific conditions outlined in Section 4.2 of the standard, this ignition loss is explicitly interpreted as the resin…
ASTM D2581-09, titled Standard Classification System for Polybutylene (PB) Plastics Molding and Extrusion Materials, establishes a comprehensive classification system for these specific thermoplastics. This system allows for identifying materials in accordance with types and categories and is intended as a…