Physical Address
304 North Cardinal St.
Dorchester Center, MA 02124
ASTM D3716-14 (Reapproved 2020) provides standardized test methods for evaluating emulsion polymers used as the primary film-forming component in water-based floor polishes. These methods are designed to help formulators and quality control laboratories assess the consistency and basic properties of…
ASTM D3717-85a provides a standardized method for determining low concentrations of antimony in paint by atomic absorption spectroscopy. The method is applicable for antimony levels from 50 to 200 ppm (mg/kg) in solids of liquid coatings or dried films. This…
📐 Scope and Applicability of D3712-18 The ASTM D3712-18 standard, formally designated as a joint ASTM-IP standard (369/(95)), provides a comprehensive liquid chromatography method for the analysis of oil-soluble sulfonates. This test method is applicable to both refined and crude…
📐 Scope and Application This practice, designated D3715/D3715M, establishes uniform quality assurance provisions for pressure‑sensitive tapes. It provides sampling plans and procedures for acceptance inspection specifically for cases where an upper or lower specification limit is given. The practice does…
🔬 Overview and Scope of the Standard Test Method ASTM D3710 – 95 (Reapproved 2009), formally known as “Standard Test Method for Boiling Range Distribution of Gasoline and Gasoline Fractions by Gas Chromatography”, defines the gas chromatography distillation (GCD) method…
📐 Scope and Summary of ASTM D3711 ASTM D3711 – 95 (Reapproved 2009), formally titled the Standard Test Method for Deposition Tendencies of Liquids in Thin Films and Vapors, establishes a methodology to determine the propensity of petroleum-based and synthetic…
📐 Product Types and Classifications This specification covers asphalt roll roofing in sheet form, typically 36 in. (914 mm) wide, used as a cap sheet in built-up roofs. The material is classified into four types based on minimum mass per…
ASTM D3708 – 88 (Reapproved 2010) specifies a standard test method for determining the weight of hot melt wax applied to corrugated board by curtain coating. This method is critical for process control in manufacturing to ensure consistent barrier properties…
ASTM D3709 – 89 (Reapproved 2010), “Standard Test Method for Stability of Water-in-Oil Emulsions Under Low to Ambient Temperature Cycling Conditions,” provides a standardized procedure for evaluating how well water-in-oil emulsions resist breakdown when subjected to repeated freeze-thaw cycles. This…
ASTM D3706-88 (Reapproved 2000), an American National Standard, defines a standardized method for evaluating the hot tack of wax-polymer blends used in flexible packaging heat seal applications. This test method relies on the Flat Spring Test to determine the cohesive…