Physical Address
304 North Cardinal St.
Dorchester Center, MA 02124
🧪 Overview and Scope of the Standard ASTM D4196-05 (Reapproved 2019) establishes a standardized test method for confirming the sterility of analytical membrane filters. This applies to both manufacturer presterilized filters and those sterilized by the user in-house. The test…
🧪 Scope and Summary of Test Methods ASTM D4198‑20 defines standardized test methods for evaluating the liquid‑holding capacity and the biological compatibility of absorbent pads used as nutrient reservoirs in membrane‑filter bacteriological analysis. The methods apply primarily to 47 mm diameter…
📖 Scope and Terminology ASTM D4194-23 defines standardized test methods for determining the operating characteristics of reverse osmosis (RO) and nanofiltration (NF) devices. The standard is divided into three specific test methods: Brackish Water Reverse Osmosis Devices (Test Method A,…
🔬 Scope and Significance of Feed Water Characterization ASTM D4195-23 provides the definitive framework for conducting the essential water analyses required when evaluating reverse osmosis (RO) or nanofiltration (NF) applications. Proper feed water characterization is the foundation for system design,…
The ASTM D4193-08 standard, reapproved in 2020, provides a quantitative colorimetric test method for determining dissolved thiocyanate in water, waste water, and saline water. This method is widely used for environmental monitoring and industrial effluent analysis to ensure compliance with…
🔬 Scope and Summary of the Method ASTM D4191−15 specifically addresses the analysis of low concentrations of sodium in low-solids waters using flame atomic absorption spectrophotometry (AAS). The validated applicable range for this method is 0.20 to 3.0 mg/L when…
The ASTM D4192-15 standard defines a precise methodology for determining low concentrations of potassium in water samples using flame atomic absorption spectrophotometry (FAAS). Geared towards waters with low dissolved solids, this method offers a straightforward approach for environmental, agricultural, and…
This article summarizes the key technical requirements and analytical procedures defined in ASTM D4190-15 (Reapproved 2023), titled “Standard Test Method for Elements in Water by Direct-Current Plasma Atomic Emission Spectroscopy”. This method, under the jurisdiction of Committee D19 on Water,…
🧪 Scope and Significance of ASTM D4188 ASTM D4188-17, “Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test in Water,” is a critical standard under the jurisdiction of ASTM Committee D19 on Water. This practice outlines a method for evaluating the…
🔬 Introduction and Scope of D4189-23 The Silt Density Index (SDI) test, formally defined in ASTM Standard D4189-23, is a critical measurement for evaluating the fouling potential of water in membrane systems. It provides an index calculated from the rate…