Physical Address
304 North Cardinal St.
Dorchester Center, MA 02124
D2680-20 – Standard Test Method Technical Guide
📐 Scope and Application
ASTM D2680-20 standardizes the specification for composite sewer piping made from Acrylonitrile-Butadiene-Styrene (ABS) and Poly(Vinyl Chloride) (PVC). This specification covers thermoplastic composite pipe, fittings, and joining systems designed for gravity flow, non-pressure sanitary sewer, and storm drain installations. The pipe and fittings are manufactured using ABS or PVC plastic materials, and the standard recommends following Appendix X1 for installation practices.
🛠️ Material Requirements and Testing
The standard references several ASTM test methods to ensure material quality and performance. For instance, Test Method D2122 is used for determining dimensions of thermoplastic pipe and fittings, while D2412 measures external loading characteristics through parallel-plate loading. Additionally, D2152 assesses the adequacy of fusion for PVC pipe using acetone immersion. These tests are critical for verifying compliance with the specification.
| 🟦 Test Method | 📏 Purpose | 🎯 Key Measurement |
|---|---|---|
| D2122 | Determining Dimensions | Diameter, Wall Thickness |
| D2412 | External Loading Characteristics | Pipe Stiffness |
| D2152 | Adequacy of Fusion | Acetone Immersion |
⚙️ Key Specifications and Conditions
The standard specifies that values stated in inch-pound units are standard, with SI units provided for reference. It also highlights safety hazards associated with the test methods, emphasizing the responsibility of users to establish appropriate safety, health, and environmental practices. The development of this international standard follows WTO principles on standardization.
💡 Tip: When using this standard, always refer to the latest edition of referenced ASTM documents such as D618 for conditioning plastics, D2321 for underground installation, and F402 for safe handling of solvent cements.
✅ Compliance Note: All materials and fittings must meet the requirements specified in Classifications D1784 and D3965 for PVC and ABS compounds respectively.
❓ Frequently Asked Questions
🔍 What materials are used in D2680-20 piping?
The piping is made from Acrylonitrile-Butadiene-Styrene (ABS) or Poly(Vinyl Chloride) (PVC) plastic materials, as specified in the standard.
💡 What types of installations are covered?
It covers gravity flow, non-pressure sanitary sewer, and storm drain installations.
⚡ Are there any safety considerations?
Yes, the standard includes a safety hazards caveat for the test methods and requires users to establish appropriate safety practices.
📌 What units are used in this standard?
Inch-pound units are standard, with SI units provided for information only.