Category SAE Standards

This article provides an overview of the remanufacturing procedures for automotive starter solenoids as outlined in SAE J2242 (2008). Although the standard is now designated as noncurrent due to a loss of committee expertise, its recommendations serve as a critical…

Clear and consistent terminology is the foundation of effective engineering communication. The SAE J645 standard, revised in 2022, provides a comprehensive set of definitions for automotive transmissions, transaxles, and electrified transmissions. This updated recommended practice reflects the rapid evolution of…

Although antiquated in design compared to today’s serpentine belt drives, V-belts remain common in many emerging markets. The SAE J637-2012 standard, stabilized in 2012, serves as a critical reference for classical automotive V-belt drive systems. It provides dimensional and performance…

Introduced in 1950 and revised in 2021, SAE J673 remains an essential recommended practice for specifying safety glazing materials in motor vehicles. It provides guidance on definitions, dimensional tolerances, and practical considerations for glass, plastic, and glass-plastic combinations. This article…

The SAE J2241 standard (now noncurrent) provides thorough guidelines for remanufacturing starter drive assemblies for automobiles and light trucks. These recommended practices promote consistency in reliability, durability, and safety for rebuilt starters. The following sections outline the critical steps, specifications,…

Remanufacturing automotive starters is a cost-effective alternative to replacement, provided that the core is suitable and the procedures follow established standards. SAE J2073 (Noncurrent, 2008) provides minimum recommended guidelines for light-duty starter remanufacturing to promote consistent reliability, durability, and safety.…

SAE J530-2024 is the latest revision of the standard covering pipe fittings used in automotive and mass production industries. This update adds minimum working pressure and burst pressure requirements, providing clearer guidelines for low and medium pressure applications. The standard…

SAE J771 has been a foundational standard for automotive printed circuits since its initial issuance in 1961. Stabilized in 2012, this standard represents mature technology that continues to guide engineers in designing reliable printed circuit boards (PCBs) for the demanding…

The SAE J120-2002 standard provides comprehensive guidelines for rubber O-rings and rectangular seal rings used in automotive sealing applications. This article summarizes the key requirements for materials, dimensions, and gland design to help engineers select and apply these seals effectively.…

Ignition system performance directly affects engine efficiency, emissions, and reliability. The SAE J973-2020 standard defines recommended practices for characterizing distributorless battery ignition systems in a controlled test-bench environment. Whether you are calibrating an ECU or validating a new coil design,…