Category SAE Standards

This article provides an overview of SAE J1101, the standard test procedure for evaluating the parking stability of two-wheel motorcycles equipped with side stands or center stands. Understanding this standard is essential for engineers designing parking stand systems and for…

SAE J1102M-2016 defines the mechanical and material requirements for metric wheel bolts used in automotive vehicles. This surface vehicle standard covers strength grades, thread dimensions, torque recommendations, and corrosion protection for these critical fasteners. Although now stabilized, it remains a…

The SAE J1092 standard, published by SAE International, provided a consistent naming system for major components of general purpose wheel industrial tractors. Initially issued in 1974, the standard was cancelled in May 2003 due to limited demand. Despite its cancellation,…

The SAE J1093-2020 standard provides an analytical framework to evaluate the structural competence of wire rope–supported, latticed boom systems on mobile construction cranes. This procedure complements physical testing per SAE J987 and helps engineers determine safe load ratings, assess elastic…

This article summarizes the key elements of the cancelled SAE J110-2002 standard, which provided recommended practices for testing radial lip type seals used in rotating shaft applications across automotive and off-highway equipment. Although superseded, the standard established essential equipment and…

⚠️ Important: SAE J1088 was officially cancelled in March 2013 and should not be used for regulatory compliance. Background and Cancellation SAE J1088 was a recommended practice that provided a test procedure for measuring gaseous exhaust emissions from small utility…

The SAE J109-2014 standard, stabilized by the SAE Motorcycle Technical Steering Committee, establishes the performance requirements for service brake systems on motorcycles and motor-driven cycles intended for highway use. This recommended practice ensures that brake systems deliver consistent, safe deceleration…

1. Understanding SAE J1091-2013 SAE J1091-2013 specifies a stationary test method for determining the masking effect of machine parts on a visibility test circle around the machine, from the seated operator’s eye position. Originally issued in 1996 and revised in…

Understanding the Scope and Key Definitions SAE J1085-2017 describes procedures for measuring dynamic characteristics of automotive elastomeric mountings using forced vibration testing. The standard focuses on key parameters: elastic spring rate (dynamic stiffness K’), damping coefficient (C), and loss tangent…

SAE J1086 is a recommended practice that establishes a uniform numbering system for metals and alloys used in the automotive industry. First issued in 1974 and stabilized in 2012, this standard reflects mature technology that is not expected to change,…