Physical Address
304 North Cardinal St.
Dorchester Center, MA 02124
ASTM D1763-00 (Reapproved 2021) covers totally reactive epoxy resins supplied as liquids or solids. These resins are designed for castings, coatings, tooling, potting, adhesives, and reinforced applications. Polymerization requires the addition of hardeners in proper proportions to form infusible products.…
📋 Types, Classes, and Grades of Compounds ASTM D1764-97, also approved as SAE J19, provides a classification system for compounded latex materials used in dipped automotive goods and coatings. The standard divides compounds into two primary types based on their…
📐 Scope and Terminology ASTM D1760 – 01, Standard Specification for Pressure Treatment of Timber Products, establishes the requirements for treating round, sawn, and otherwise fabricated timber products—including utility poles, piles, posts, crossties, lumber, timbers, glued laminated timbers, and plywood—with…
📐 Scope, Referenced Documents, and Fastener Types ASTM D1761-20 provides standardized procedures for evaluating the withdrawal and lateral resistance of mechanical fasteners installed in wood and wood-based materials. The standard primarily covers driven fasteners (nails, spikes, and staples), screwed fasteners,…
📐 Specimen Geometry and Types ASTM D1758-06 defines two test methods based on stake size. Method A uses 3 square stakes for accelerated testing, while Method B employs nominal 2-by-4 in. stakes for longer-term evaluations. The preferred wood is sapwood…
📐 Physical Test Methods ASTM D176 – 07 specifies physical tests for solid filling and treating compounds, including melting point (Sections 5-6), softening point (7-8), flash and fire points (9-10), viscosity (13-14), penetration (15-16), specific gravity (17-21), coefficient of expansion…
📐 Overview and Scope of Test Method D1756 ASTM D1756 – 02 (Reapproved 2007) provides a standardized gravimetric procedure for the determination of carbon dioxide (CO₂) released from coal in the form of mineral carbonates through treatment with mineral acids.…
🔍 Scope and Significance This standard test method, designated D 1757 – 03, is specifically tailored for the determination of sulfate sulfur in the ash derived from coal and coke. The values stated in SI units, in accordance with Practice…
📐 Product Types and Material Composition The ASTM D1752-18 specification outlines the requirements for four distinct types of preformed expansion joint fillers used in concrete, brick, or stone construction. The material composition for each type is strictly defined in Section…
📐 Scope and Significance of the Thin-Film Oven Test ASTM D1754/D1754M – 20, under the jurisdiction of ASTM Committee D04 on Road and Paving Materials and Subcommittee D04.46 on Durability and Distillation Tests, establishes the standard test method for determining…