Physical Address
304 North Cardinal St.
Dorchester Center, MA 02124
📐 Scope, Referenced Documents, and Fastener Types ASTM D1761-20 provides standardized procedures for evaluating the withdrawal and lateral resistance of mechanical fasteners installed in wood and wood-based materials. The standard primarily covers driven fasteners (nails, spikes, and staples), screwed fasteners,…
📐 Specimen Geometry and Types ASTM D1758-06 defines two test methods based on stake size. Method A uses 3 square stakes for accelerated testing, while Method B employs nominal 2-by-4 in. stakes for longer-term evaluations. The preferred wood is sapwood…
📐 Physical Test Methods ASTM D176 – 07 specifies physical tests for solid filling and treating compounds, including melting point (Sections 5-6), softening point (7-8), flash and fire points (9-10), viscosity (13-14), penetration (15-16), specific gravity (17-21), coefficient of expansion…
📐 Overview and Scope of Test Method D1756 ASTM D1756 – 02 (Reapproved 2007) provides a standardized gravimetric procedure for the determination of carbon dioxide (CO₂) released from coal in the form of mineral carbonates through treatment with mineral acids.…
🔍 Scope and Significance This standard test method, designated D 1757 – 03, is specifically tailored for the determination of sulfate sulfur in the ash derived from coal and coke. The values stated in SI units, in accordance with Practice…
📐 Product Types and Material Composition The ASTM D1752-18 specification outlines the requirements for four distinct types of preformed expansion joint fillers used in concrete, brick, or stone construction. The material composition for each type is strictly defined in Section…
📐 Scope and Significance of the Thin-Film Oven Test ASTM D1754/D1754M – 20, under the jurisdiction of ASTM Committee D04 on Road and Paving Materials and Subcommittee D04.46 on Durability and Distillation Tests, establishes the standard test method for determining…
📐 Scope and Classification of PVC Resins This specification, designated D1755-21, establishes comprehensive requirements for homopolymers of vinyl chloride in their original powder form. These resins are intended for subsequent mixing and processing into thermoplastic compositions. The standard explicitly defines…
This standard practice provides essential guidance for planning, conducting, and interpreting interlaboratory studies specifically for test methods used with paper and paper products. It is designed to help task groups determine the variability of test results across laboratories and to…
ASTM D1751-23 defines the standard specification for preformed expansion joint fillers used in concrete paving and structural construction. Classified as the nonextruding and resilient asphalt type, these fillers are designed to accommodate thermal expansion and contraction while resisting extrusion and…