Physical Address
304 North Cardinal St.
Dorchester Center, MA 02124
The SAE J502-2018 standard, stabilized in January 2018, provides the definitive specification for Woodruff keys used in surface vehicles and general mechanical assemblies. It defines material requirements, key dimensions, and corresponding keyway dimensions to ensure interchangeability, proper fit, and reliableā¦
🛠️ Stabilized Standard Notice: SAE J503 has been stabilized, indicating that the technology is mature and not likely to change. Always verify that the referenced dimensions and formulas remain suitable for your current design needs. Overview of SAE J503-2018 SAEā¦
SAE J499-2014 addresses parallel side splines used in soft broached holes in fittings. This standard covers four-, six-, ten-, and sixteen-spline configurations and provides dimensions, tolerances, and torque capacity data. It is important to note that the standard has beenā¦
SAE J500-1995 is a recommended practice focused on inch serrated shaft ends and corresponding hole dimensions for service applications. It provides standard dimensions, tolerances, and formulas for 36 and 48 serration configurations, ensuring consistent fits and reliable performance in automotiveā¦
SAE J493, originally issued in 1915 and stabilized in 2013, specifies the requirements for rod ends and clevis pins used in automotive and industrial applications. This article provides an overview of the standard, its material specifications, and important considerations forā¦
SAE J495-2004, originally issued in 1957 and cancelled in May 2004, was the industry standard for solid straight pins used in various mechanical assemblies. While it is no longer recommended for new designs, understanding its specifications helps engineers working withā¦
Overview and Cancellation SAE J497, first issued in 1957, provided the dimensional requirements for unhardened ground dowel pins used in precision alignment. However, this standard was cancelled in May 2004 as it is obsolete, with current specifications now managed underā¦
SAE J483 is a recommended practice that defines the dimensions, tolerances, and material requirements for high and low crown hex nuts, commonly referred to as blind or acorn nuts. These fasteners are widely used in automotive and industrial applications whereā¦
The SAE J490 standard, originally issued in 1920 and stabilized in 2012, provides a foundational overview of ball joints used in surface vehicles. It covers general technology, products, and processes but defers to manufacturers for specific design considerations. This articleā¦
SAE J468 is a stabilized surface vehicle standard that defines the chemical composition requirements for two widely used zinc alloys in both ingot and die casting forms. Originally issued in 1934 and stabilized in 2018, the standard reflects mature technologyā¦