Physical Address
304 North Cardinal St.
Dorchester Center, MA 02124
📋 Overview and Scope ASTM D5088-20 sets forth a standard practice for decontaminating field equipment used in sampling soils, soil gas, sludges, surface water, and groundwater at chemical waste sites. This practice is designed for sites where organic and inorganic…
🧪 Scope and Analytical Methodology ASTM D5086-20, under the jurisdiction of Committee D22 on Air Quality, defines a definitive protocol for the determination of calcium (Ca), magnesium (Mg), potassium (K), and sodium (Na) in atmospheric wet deposition. The method is…
🎯 Standard Overview and Scope ASTM D5087-02 (Reapproved 2021) specifies a laboratory test method for quantifying the mass of Volatile Organic Compounds (VOC) released from applied solventborne automotive coatings that is available for delivery to a downstream VOC control device…
🧪 Scope and Method Detection Limits This test method, designated D5085-21, is applicable to the determination of chloride, nitrate, and sulfate in atmospheric wet deposition samples (rain, snow, sleet, and hail) by suppressed ion chromatography. The concentration ranges were confirmed…
📐 Overview of Test Methods and Systems ASTM D5084‑24 describes six alternative hydraulic systems for measuring the hydraulic conductivity (coefficient of permeability) of water-saturated porous materials using a flexible wall permeameter. These methods are designed to accommodate materials with varying…
📐 Materials and Definitions Poly(Vinyl Chloride) Sheets Roofing must conform to the requirements of ASTM Specification D4434 (Section 4.1). Lap seam sealant, when required by the manufacturer/supplier, shall be a compatible sealant applied to the exposed edge of the seam…
📐 Scope and Specimen Configuration ASTM D5083-17 establishes a standardized procedure for determining the tensile properties of thermosetting reinforced plastics using straight-sided specimens of uniform nominal width. Based on current experience, this method is primarily validated for glass-reinforced thermoset systems…
ASTM D5081/D5081M – 90 (Reapproved 2024) establishes a standard laboratory protocol for determining the aggregate layer hiding power. By quantifying the mass of gravel required to prevent light transmission, this method provides critical data for designing roofing systems that protect…
ASTM D5080-20 describes a rapid test method for determining percent compaction and variation from optimum water content in compacted earth. This method utilizes a three-point compaction curve developed from in-place soil without prior water content knowledge, facilitating efficient construction control.…
The ASTM D5079-08 standard establishes comprehensive practices for the preservation, transportation, storage, cataloging, retrieval, and post-test disposition of rock core samples. These practices are critical for maintaining sample integrity from the field to the laboratory, ensuring that test results accurately…