Category SAE Standards

SAE J2054 defines a standardized protocol for diagnostic communication between test tools and vehicle electronic control units (ECUs). Originally issued in 1990 and cancelled in June 2001, this standard provides a framework for diagnostic test modes, message formatting, and device…

SAE J2028-2016 is a stabilized recommended practice that establishes uniform testing and performance criteria for elastomeric boot seals used in constant velocity (CV) joints, primarily in front-wheel-drive halfshafts. This standard is essential for engineers and manufacturers involved in the design,…

Scope and Definitions The SAE J2034 standard establishes uniform test procedures and performance requirements for ventilation systems in personal watercraft (PWC). It specifically addresses engine and fuel tank compartments. This 2023 revision aligns with ISO 13590:2022 to harmonize international requirements.…

When integrating an internal combustion engine into a vehicle or industrial application, accurate knowledge of its weight, dimensions, center of gravity, and moment of inertia is critical. SAE J2038, a recommended practice originally published in 1990 and cancelled in 2000,…

SAE J2004 was an industry standard that specified dimensional features and requirements for expander/segment oil control rings used in internal combustion engines. Published in 2008, it covered ring types ES-1 through ES-5, materials for expanders and segments, chromium coating thicknesses,…

SAE J2019 was a standardized method for testing the weatherability of automotive exterior materials using a controlled irradiance air-cooled xenon-arc apparatus. Initially issued in 1994, it was cancelled in November 2012 due to the obsolescence of the specified instruments. Though…

🛠️ SAE J1995-2014, titled “Engine Power Test Code – Spark Ignition and Compression Ignition – Gross Power and Torque Rating,” provides a standardized basis for dynamometer determination of gross engine power and torque. This standard is essential for engine manufacturers…

SAE J2000, cancelled in June 2008, specifies essential dimensional features of keystone piston rings for reciprocating internal combustion engines up to 200 mm diameter. It covers six ring types: T, TB, TM (6-degree) and K, KB, KM (15-degree). Although superseded…

SAE J2001, Internal Combustion Engines—Piston Rings—Half Keystone Rings, defines essential dimensional and force-related features for HK and HKB half keystone rings with narrow ring widths. Although cancelled in 2008 in favor of ISO 6624‑2, this standard remains a reference for…

The SAE J1987 recommended practice has long served as a reference for accurately determining the steady-state force and moment properties of passenger car and light truck tires. This standardized test method, performed on a belt-type flat surface machine, enables engineers…