Category ASTM Standards

📐 Scope and Specimen Requirements ASTM D2591-07 (Reapproved 2020) specifies a test method for determining the linear density of short lengths of “as produced” elastomeric yarns made from rubber, spandex, or other elastomers. It is applicable to yarns in the…

🔬 Scope and Application This test method covers the determination of butadiene-1,3 purity and hydrocarbon impurities including propane, propylene, isobutane, n-butane, butene-1, isobutylene, propadiene, trans-butene-2, cis-butene-2, butadiene-1,2, pentadiene-1,4, and various acetylenes (methyl, dimethyl, ethyl, and vinyl) in polymerization grade butadiene.…

ASTM D2594/D2594M-21 defines a standard test method specifically designed for evaluating the stretch and growth characteristics of knitted fabrics that exhibit high extension under low tension, commonly referred to as low-power stretch fabrics. Unlike tests for rigid or power-net fabrics,…

📐 Scope and Significance of McNett Wet Classification This test method, designated ASTM D2589/D2589M, covers the determination of the length distribution and fines content of milled asbestos fiber through wet classification using the McNett fiber classifier. The values stated in…

This article provides a comprehensive overview of ASTM D2590/D2590M −98 (Reapproved 2019), the standard test method specifically designed for the controlled sampling of milled chrysotile asbestos fibers. The standard outlines a rigorous protocol for obtaining representative test specimens from bulk…

🧪 Scope and Principle of the Barcol Impressor Test ASTM D2583-24 defines a standardized method for measuring the indentation hardness of rigid plastics, encompassing both reinforced and non-reinforced types, through the use of a Barcol Impressor. The test is specifically…

📜 Scope, Significance, and Limitations ASTM D2584‑18 provides a standardized procedure for determining the ignition loss of cured reinforced resins. Under the specific conditions outlined in Section 4.2 of the standard, this ignition loss is explicitly interpreted as the resin…

ASTM D2581-09, titled Standard Classification System for Polybutylene (PB) Plastics Molding and Extrusion Materials, establishes a comprehensive classification system for these specific thermoplastics. This system allows for identifying materials in accordance with types and categories and is intended as a…

ASTM D2582-21 is the standard test method designed to measure the dynamic tear resistance of plastic film and thin sheeting when exposed to snagging-type hazards encountered in end-use applications. The test simulates the puncture and subsequent propagation of a tear,…

📋 Test Method Summary and Scope The ASTM D2579-93 standard specifies a test method for the determination of Total Organic Carbon (TOC) in a wide range of aqueous matrices, including water, wastewater, brackish waters, and brines. The explicitly stated working…

📐 Scope and Applicability ASTM D2580-06 (Reapproved 2012) defines a direct aqueous injection procedure for the gas-liquid chromatographic (GLC) determination of phenols, cresols, and mono- and di-chlorophenols in water. The test method is specifically applicable to waste waters and concentrates…

📝 Scope and Referenced Test Methods ASTM D2575-70 (Reapproved 1998) covers the selection and application of procedures for testing polymerized fatty acids. Rather than providing fully detailed procedures, it specifies the use of related ASTM standard test methods for critical…