Category ASTM Standards

The ASTM D3154-14 (Reapproved 2023) standard, developed by Committee D22 on Air Quality, describes the standard test method for measuring average velocity in ducts using the Pitot tube method. This method is technically complex but is considered the most accurate…

🔬 Scope and Summary of Test Method This test method, designated ASTM D3152 – 72 (Reapproved 2000), covers the determination of capillary-moisture properties of fine-textured soils. It specifically utilizes a pressure-membrane apparatus to establish the moisture content vs. moisture tension…

🧪 Scope and Key Terminology for D3153-23 This test method covers the determination of the effects of applying a water-emulsion floor polish over a dried coating of the same polish. It is specifically designed for laboratory bench panel testing, although…

📐 Scope and Classification ASTM D3150-21 specifies the requirements for flexible, crosslinked and noncrosslinked poly(vinyl chloride) (PVC) heat-shrinkable tubing used for electrical insulation. The tubing is supplied in an expanded form and shrinks to its extruded diameter when exposed to…

The ASTM D 3151 – 88 (Reapproved 1998) standard, formally titled the Standard Test Method for Thermal Failure of Solid Electrical Insulating Materials Under Electric Stress, specifically addresses the phenomenon of thermal dielectric runaway at commercial power frequencies. It is…

ASTM D3149-06 (Reapproved 2013) is the definitive specification for crosslinked polyolefin heat-shrinkable tubing used for electrical insulation. The material is supplied in an expanded form and shrinks precisely to its extruded diameter when heat is applied. This standard serves as…

🧵 Classification, Composition, and Safety Requirements ASTM D315/D315M covers woven asbestos tape with a minimum of 75% asbestos fiber by weight, excluding the weight of other reinforcing strands that may be present. The standard defines three distinct classes based on…

📖 Overview and Significance of ASTM D3148‑02 ASTM D3148‑02, titled “Standard Test Method for Elastic Moduli of Intact Rock Core Specimens in Uniaxial Compression,” establishes a uniform procedure for characterizing the fundamental deformation behavior of rock materials under axial load.…

📐 Scope and Specimen Configuration This test method covers the determination of thermal endurance of electrical insulating varnishes alone or in combination with magnet wire insulation. The helical coil bond strength serves as the test criterion. Coils are constructed from…

ASTM D3147-21 establishes standardized screening procedures for the preliminary evaluation of stop-leak additives intended for use in engine cooling systems. This test method assesses the ability of a material to seal simulated leaks under controlled conditions of temperature, pressure, and…

🔍 Scope and Application The D3143/D3143M-19 standard defines the test method for determining the flash point of cutback asphalts using the Tag open-cup apparatus. It is intended for materials with flash points below 93 °C [200 °F]. This method is…

ASTM D3144-23 establishes the requirements for semirigid, flame-retardant, crosslinked poly(vinylidene fluoride) (PVDF) and PVDF copolymer heat-shrinkable tubing used for electrical insulation. The tubing is supplied in an expanded form and reliably shrinks to its original extruded diameter upon application of…