Physical Address
304 North Cardinal St.
Dorchester Center, MA 02124
⚙️ Test Method Overview and Instrument Configuration This standard, designated ASTM D2998-89 (Reapproved 1996), outlines a gas chromatographic method for the qualitative and quantitative determination of polyhydric alcohols (polyols) in alkyd resins. The procedure involves drying the resin sample, releasing…
📐 Scope, Materials, and Terminology This specification establishes the requirements for outside diameter-controlled polybutylene (PB) plastic pipe, produced in standard thermoplastic pipe dimension ratios (SDR) and pressure rated for water. It serves as a comprehensive guide for classifying PB materials,…
📐 Specification Overview and Terminology ASTM D2997-21 governs machine-made glass-fiber-reinforced thermosetting-resin pressure pipe fabricated by centrifugal casting. In this process, resin and glass reinforcement are applied to the interior of a rotating heated mold; the pipe’s outside diameter is fixed…
📋 Practice Overview ASTM D2995‑23 outlines standard methods for estimating the transverse and longitudinal application rate and residual application rate of bituminous distributors. This practice is essential for quality control in pavement surface treatments. It covers both Option A (immediate…
📜 Overview and Scope ASTM D2996-23, formally the Standard Specification for Filament-Wound “Fiberglass” (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe, defines the exacting requirements for machine-made RTRP pressure pipe. It covers nominal pipe sizes up to 60 inches and provides a comprehensive classification system.…
This specification covers one grade of rubberized tar for use in construction of rubberized tar concrete pavement. The material consists of unvulcanized acrylonitrile butadiene rubber (NBR) preblended with high‑temperature residual coke oven tar, free from asphalt or petroleum contamination. 🛢️…
🧪 Introduction and Scope of D2994-98 ASTM D2994-98 provides a suite of standardized test methods for evaluating the physical and rheological properties of rubberized tar. As defined in its Significance and Use statement (Section 3), the primary purpose of these…
The ASTM D2990-17 standard provides standardized methods for evaluating the time-dependent deformation (creep) and failure under sustained load (creep-rupture) of plastics. These tests are critical for engineering design where materials are subjected to long-term static loads under specified environmental conditions.…
📐 Scope and Application This standard practice, D2992-24, establishes two procedures—Procedure A (cyclic) and Procedure B (static)—for obtaining a hydrostatic design basis (HDB) or pressure design basis (PDB) for fiberglass piping products, including RTRP (glass-fiber-reinforced thermosetting-resin pipe) and RPMP (glass-fiber-reinforced…
📐 Standard Scope and Method Overview ASTM D2989‑01 (Reapproved 2022) specifies a test method for determining acidity or alkalinity in halogenated organic solvents and their admixtures. The standard covers acidity determination; alkalinity may be measured using Test Methods D2106 with…