Physical Address
304 North Cardinal St.
Dorchester Center, MA 02124
The SAE J80 standard, originally issued in 1982, provided a comprehensive set of requirements and testing methods for automotive rubber floor mats. It covered five types of rubber compounds and specified physical properties such as hardness, tensile strength, tear resistance,…
Overview and Test Procedure SAE J815, originally issued in 1962 and formally cancelled in November 2012, was a recommended practice that defined a method for load deflection testing of urethane foams used in automotive seating. The standard provided a consistent…
The SAE J817-2-2009 standard (cancelled December 2009, superseded by J817) provides engineering design guidelines for evaluating maintainability of off-road work machines. It establishes a point system to minimize subjectivity in assessing how easy a machine is to service, encouraging designers…
🛠️ Understanding brake performance under real-world conditions is critical for heavy vehicle safety. SAE J786a (1998) provides a uniform procedure for level road testing of brake systems on new trucks, buses, and combination vehicles. This standard covers vehicles from light…
Blast cleaning is a fundamental mechanical pre-treatment process used across industries to clean and prepare surfaces. The SAE J792-2022 standard provides a comprehensive manual that defines blast cleaning, traces its evolution, and describes current best practices in equipment, abrasives, and…
The SAE J774-2011 standard, first issued in 1961 and stabilized in 2011, specifies comprehensive requirements for emergency warning devices—such as reflective triangles and warning signs—and their protective containers. This article provides an overview of key technical requirements, engineering design insights,…
This article provides a practical overview of SAE J78-2021, the SAE standard for carbon steel self-drilling tapping screws. It covers the key specifications, dimensional requirements, and performance criteria for Types BSD and CSD screws, helping engineers select and apply these…
SAE J781a, originally approved in 1960 and last revised in June 1965, provides a standardized procedure for assigning a unique identification number to new battery types. This system helps maintain an organized selection chart by considering physical dimensions, terminal arrangement,…
This article provides an overview of the SAE J772-2017 recommended practice, which defines the clearance envelopes for six-bolt regular-duty, eight-bolt heavy-duty, and side- and rear-mounted truck transmission power takeoffs (PTOs). The standard is stabilized by SAE and serves as a…
Understanding Conical Spring Washers and Their Types The SAE J773-2016 standard specifies two types of general purpose conical spring washers: Type L and Type H. These are available in narrow, regular, and wide series to provide appropriate load distribution. Type…