Physical Address
304 North Cardinal St.
Dorchester Center, MA 02124
📐 Introduction and Hydrogeologic Context This standard guide, D5717-95, addresses the design of ground-water monitoring systems in karst and fractured-rock aquifers, where hydrogeologic characteristics differ significantly from porous media. The focus is on unconfined karst systems with increased secondary porosityā¦
📐 Test Method Overview and Scope This test method, designated as D5716/D5716M-20, covers the construction and operation of a circular orifice weir for measuring the discharge from a well. It is part of a series of standards prepared for theā¦
📐 Scope and Categories of Use ASTM D5714-95 (Reapproved 2002) specifies the information content for metadata of digital geospatial data. It establishes a common set of terminology and definitions for related concepts. This specification addresses minimum content and processing requirementsā¦
ASTM D5715-23 outlines a standardized practice for estimating the degree of humification of peat and other highly organic soils through visual evaluation of water expelled upon compression. This field method is crucial for peatland inventories and resource assessments, supplementing otherā¦
ASTM D5713-23 defines a standardized procedure for capillary gas chromatography analysis of high-purity benzene intended for cyclohexane feedstock. This method is essential for quantifying specific impurities and verifying final product purity, supporting both process control and end-product certification within theā¦
The ASTM D5711-03 standard provides a definitive test method for quantifying the material that adheres to the surface of coarse aggregate particles. This test is vital for quality control in hot mix asphalt (HMA), seal coats, surface treatments, and portlandā¦
🧪 Test Method Scope ASTM D5712-15 defines a standardized procedure for the analysis of total aqueous extractable protein in natural rubber, latex, and elastomeric products. Water-soluble proteins are extracted in a buffer solution, precipitated to concentrate them and separate themā¦
🏗️ Manufacture and Composition Requirements Trinidad Lake Modified Asphalt is a specialty binder produced by blending naturally occurring Trinidad Lake Asphalt (TLA) with petroleum-based asphalt cement. According to Section 3.1 of ASTM D5710/D5710M-22, the TLA component must constitute between 20%ā¦
📐 Scope and Methodology Overview ASTM D5708-15 (Reapproved 2020) defines standardized procedures for determining nickel (Ni), vanadium (V), and iron (Fe) in crude oils and residual fuels via inductively coupled plasma atomic emission spectrometry (ICP-AES). The standard provides two distinctā¦
📐 Scope and Material Requirements ASTM D5709-22 specifies a standardized dry sieving procedure for determining the particle size distribution of petroleum coke. The test method covers green petroleum coke with a topsize of no more than 75 mm and sizeā¦